Connect Two Computers using a Crossover Cable

These are instructions on how to make a cat 5 crossover cable.
To make a "Crossover" cable you change the pin out connections on one end of the cable. If you do it on both ends of the cable you have crossed-over the crossover and now have a straight-through cable.

Requirements

1. 2 meter CAT 5 (or CAT 5e /6) cable (Cable length depends on you),
2. 2 RJ45 Connecters,
3. Wire Cutter
4. RJ45  Crimper for Pressing RJ45 Pins into the Cable

Now cut the each pins one by one using wire cutter and join Pins 1 & 2 from one end are connected to pins 3 & 6 on the other end, and pins 3 & 6 from the first end are connected to pins 1 & 2 on the other end. Pins 4 & 5 and 7 & 8 don't change.
 
The pin outs looking from the bottom of the cat 5 end are as follows:

Standard End	Crossover End
Pin 1 White/Orange	Pin 1 White/Green
Pin 2 Orange	Pin 2 Green
Pin 3 White/Green	Pin 3 White/Orange
Pin 4 Blue	Pin 4 Blue
Pin 5 White/Blue	Pin 5 White/Blue
Pin 6 Green Pin 6 Orange	Pin 6 Orange
Pin 7 White/Brown	Pin 7 White/Brown
Pin 8 Brown	Pin 8 Brown